Pattern sliders

The laundry basket in the house where the baby was born is filled instantly. To always have clothes replaced, you will need a lot of diapers and sliders. The ideal solution is to sew several pairs of sliders on your own, so that you do not have to do the washing too often.

How to sew sliders: tips

In order to sew the sliders the child does not need a lot of strength and skills. It is not necessary to look for some complicated patterns. In the creation of clothes for the baby will help you sliders or pants that you have. See how easy they are made, no unnecessary decorations and complex details. You can use them as a template.

To make the baby comfortable in the sliders, pay more attention to the choice of fabric and the treatment of seams. The fabric should be light, natural and soft, because cotton. The seams should not rub against the legs and cause discomfort. In no case should the rubber be tight!

Pattern sliders for newborns

In order to carve out the sliders, you need to take measurements.

Measure:

• The distance from the shoulder of the baby to the foot;
• Distance from underarm to foot;
• The length of the leg;
• Growth (if you put the sliders on the diaper, increase the length of this line by 3 cm, and reduce the length of the leg as much;
• The width of the leg at the bottom (so that you can freely wear);
• Slider width;
• The length of the foot of the baby (carve out a foot of such size that the leg was not crowded).

For babies with plump legs, an additional measure is the width of the leg at the top, so that it is not narrow.

Knowing all these sizes, you can precisely cut out and easily sew the sliders.

When cutting out the sliders, be sure to add allowances:

• Allowance for seams 0, 2 - 0, 5 cm. Depending on the type of processing;
• If necessary, add 7 cm overgrowth allowance;
• If desired, add a 2.5 cm free allowance for fit, if you sew from stretching fabric and 4 cm. If the fabric does not stretch badly;
• If you will cut on the already finished pattern, be sure to compare it with the size that you have (it is possible that it already took into account the allowances for free fit and growth). When cutting out the sliders, place them along the lobe thread.

Sew all the details in the following sequence:

1. To the front half, sew the toe, gusset and yoke (if you have them);
2. Sew the front and back halves along the side seams;
3. Sew the front and back halves along the seam of the inner edge of the leg;
4. Sew foot;
5. Handle seams;
6. Handle the top edge of the sliders and make the fastener.

How to make sliders on the elastic band?

To build a pattern of sliders on an elastic band, you will need the following measurements: waist girth, length of pants, foot length. Cut the sliders on the fabric, adding seam allowances - 0.3cm everywhere, 2.5cm on the belt.

Connect the details. Sew foot to the back halves of the sliders.

Sew the front and back halves, process the seams.

Tighten the belt and sew. Insert the gum.

It is easy to sew the sliders even for those mothers who understand little in needlework. But things, sewed on their own, will help to significantly save the family budget. Especially if there are suitable fabric cuts at home. The most important thing is to measure the baby correctly to create a pattern and leave some matter on the allowances.